Brand: For Cadillac
Product Code: C12026
Weight: 0.060 kg
Availability: In Stock
Price: $19.90

 

Replacement Remote Key Fob 6Button 315MHz for Cadillac FCC: OUC6000066 Memory 2
Button: 5+1 Buttons
Frequency: 315MHz
FCC ID: OUC6000066


Compatibility:
2014 Cadillac Escalade
2013 Cadillac Escalade
2012 Cadillac Escalade
2011 Cadillac Escalade
2010 Cadillac CTS
2010 Cadillac DTS
2010 Cadillac Escalade
2009 Cadillac CTS
2009 Cadillac DTS
2009 Cadillac Escalade
2008 Cadillac CTS
2008 Cadillac DTS
2008 Cadillac Escalade
Programming
There are 2 different procedures for 2008-2010 vehicles.
2011 and newer vehicles must be programmed by a professional automotive locksmith or dealership.


PROCEDURE #1
This procedure is for vehicles with the driver information center. It will be a button to the right of the steering wheel, with a vehicle icon and the letter i.
1.Insert key and switch the ignition ON (just shy of starting vehicle without cranking engine)
2. Press vehicle information button until PRESS TO RELEARN REMOTE KEY is displayed.
3. Press the set/reset button (button will have a checkmark) until REMOTE KEY LEARNING ACTIVE is displayed. Vehicle is now in programming mode.
4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will be heard indicating successful programming.
5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.
6. To exit programming mode turn ignition OFF, remove key and test all remotes.


PROCEDURE #2
This procedure is for vehicles without the drivers information center.
1. Insert key into the ignition and turn to ON (Just shy of starting vehicle without cranking engine).
2. Press the trip odometer reset button until RELEARN REMOTE KEY is displayed.
3. Press and hold the trip odometer reset button for approximately 3 seconds until REMOTE KEY LEARNING ACTIVE displays.
4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will be heard indicating successful programming.
5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.
6. To exit programming mode turn ignition OFF, remove key and test all remotes.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: